Technical data

Section 09 PROPULSION SYSTEM
Sub-Section 03 (REVERSE SYSTEM)
09-03-5
2, Spring
Insert spring in lever stem hole and then install
curved end in sliding block groove.
TYPICAL
1. Sliding block groove
Selector Lever System Lubrication
Lubricate sliding block support sliding area and tri-
angular lever with synthetic grease. Also, lubri-
cate sliding washer and selector lever stem.
TYPICAL
1. Sliding washer
2. Sliding block
3. Support plate
ADJUSTMENTS
Reverse Gate
Position handlebar in a straight ahead position,
nozzle should be parallel to rear of watercraft.
Using a square, set it to 129 ± 3 mm (5-5/64 ± 7/
64 in), then position square end at the top middle
of nozzle.
A. 129 ± 3 mm (5-5/64 ± 7/64 in)
Pull selector lever to REVERSE position.
TYPICAL
1. Lever to REVERSE position
With the gate down to REVERSE position it
should be at the specification.
NOTE : Push slightly on the gate in order to
recover spring tension and to obtain proper
position of the gate.
F02J0KA
1
F02D03A
1
2
3
F02J0HA
A
F02J0GA
1
www.SeaDooManuals.net