Technical data

Section 09 PROPULSION SYSTEM
Sub-Section 04 (VARIABLE TRIM SYSTEM)
09-04-4
GENERAL
To test VTS control module, motor or switch, refer
to ELECTRICAL SYSTEM 08-05.
REMOVAL
1,2,3, Ball Joint, Boot and Gear Clamp
Disconnect ball joint of link rod.
Loosen gear clamps of boot.
RRemove boot.
4,5, Nut and Seal
To loosen nut, use VTS socket tool (P / N 295 000
133).
6, VTS Assembly
From bilge, pull out VTS assembly.
DISASSEMBLY
7, Cover
Remove VTS cover by pressing on tabs.
1. Press tabs to remove cover
8, Motor
Disconnect wires of motor.
Remove retaining nuts.
1. Remove nuts
2. Disconnect wires
Pull on motor to remove it.
9,10, Worm and Sliding Shaft
Simply pull on worm and sliding shaft in order to
remove them.
INSPECTION
2, Boot
Make sure boot is in good condition. If it is
cracked or teared, replace boot.
F01J1WA
1
F01J1XA
1
2
www.SeaDooManuals.net