Technical data

Section 10 STEERING SYSTEM

Sub-Section 01 (SP /XP SERIES)

10-01-5

1. Steering stem

2. Steering stem arm

3. Support

4. Torque to 6þN•m (53þlbf•in)

5. Integrated flat key must be seated in keyway and steering stem

arm locked in place

NOTE : Once steering stem arm is properly

tightened, look between body and front sup-

port to make sure there is no gap between steer-

ing stem arm and its support. If there is a gap,

components are not properly installed.

Connect wiring harnesses.

Route throttle cable alongside bilge. Insert cable

barrel into carburetor throttle lever.

Insert throttle cable alongside choke cable in tie-

blocks.

For throttle cable adjustment, refer to FUEL SYS-

TEM 05-03.

For steering alignment, refer to ALIGNMENT 10-

04.

F01K1NA