Technical data

Section 10 STEERING SYSTEM
Sub-Section 02 (GTS AND GTI MODELS)
10-02-3
TO INSTALL HANDLEBAR ASSEMBLY:
14, Grommet
Insert throttle cable through dashboard hole and
slide grommet on cable.
Insert grommet in dashboard hole and pull it from
inside bilge.
NOTE : To ease installation, apply water on
grommet.
Insert wires of monitoring beeper and start / stop
button.
15,16,17,18, Spring Washer, Shim,
Steering Stem and Support
Insert spring washer and the shim onto steering
stem.
Insert steering stem into support.
1. Steering stem
2. Grommet
3. Shim
4. Spring washer
10,13,19,20, Steering Stem Arm, Screw,
Large Washer and Lock Washer
Properly position steering stem arm on steering
stem. Make sure to insert stem tenon into arm
mortise. Apply Loctite 271 (red) on screw threads,
install large flat washer, lock washer and screw.
Torque to 40 N•m (30 Ibf•ft).
CAUTION : Always install large flat wash-
er with the X stamped side facing the lock
washer.
WARNING : The recommended torque
and Loctite must be applied on screw.
Steering arm mortise must seat properly on
steering stem tenon.
TYPICAL
1. Steering stem arm
2. Steering stem tenon
3. Mortise
4. Large flat washer with X
5. Lock washer
6. Screw, apply Loctite 271 and torque to 40 N•m (30 Ibf•ft)
Position 8 mm flat washer on steering stopper
screw then install locking plate over steering
stem head screw.
NOTE : Ensure locking plate slot is inserted
in steering stopper screw.
Install 8 mm flat washer and secure locking plate
using a jam nut. Torque to 7 N•m (62 Ibf•in).
STEERING CABLE NOT SHOWN FOR MORE CLARITY
1. Steering stem head screw
2. Locking plate
3. Steering stopper screw
4. 8 mm flat washers
5. Torque nut to 7 N•m (62 lbf•in)
F02K05A
1
2
3
4
-
;
F01K0VA
6
5
2
1
3
4
F01K10A
2
3
1
4
5
www.SeaDooManuals.net