Technical data

Section 10 STEERING SYSTEM
Sub-Section 02 (GTS AND GTI MODELS)
10-02-4
TYPICAL
21,22,23, Steering Cable, Ball Joint and
Retaining Block
To replace steering cable, proceed as follows :
Disconnect ball joint at steering stem arm.
Remove nuts and open retaining block.
TYPICAL
1. Ball joint
2. Steering cable
3. Retaining block
Disconnect ball joint at jet pump nozzle ; then, re-
move ball joint.
24,25,26,27, Nut, Half Ring, Rubber
Washer and Retaining Ring
From bilge, unscrew nut retaining steering cable
to hull.
Remove half rings, rubber washer and retaining
ring.
NOTE : Move selector lever in reverse posi-
tion to lower reverse gate. It will ease part
removal.
Remove steering cable from tie-block and clips.
Pull out steering cable.
Assembly is essentially the reverse of disassem-
bly procedures. However pay particular attention
to the following.
22, Ball Joint
Inspect and reuse ball joints only if they are in
good condition.
Steering Alignment
For steering alignment procedure, refer to
STEERING SYSTEM 10-04.
F02K0CA
F02K0DE
1
3
2
www.SeaDooManuals.net