Technical data

ManualsBrandsSeaDoo ManualsMarineSP

Section 02 MAINTENANCE

Sub-Section 04 (STORAGE)

02-04-2

1. Grease PTO flywheel

CAUTION : Never leave any clothing, tool

or other objects near PTO flywheel and

seal carrier.

HX Model Only

Lubricate mid bearing of drive system at seal car-

rier grease fitting with synthetic grease.

1. Grease fitting

Battery

For battery removal, cleaning and storage, refer to

ELECTRICAL 08-03.

Watercraft Cleaning

Clean the bilge with hot water and mild detergent

or with bilge cleaner. Rinse thoroughly. Lift front

end of watercraft to completely drain bilge. If any

repairs are needed to body or to the hull, touch up

paint and Gelcote® repair kit are available. Refer

to SERVICE TOOLS AND PRODUCTS 01-02. Re-

place damaged labels / decals.

Wash the body with soap and water solution (only

use mild detergent). Rinse thoroughly with fresh

water. Remove marine organisms from the hull.

Apply a nonabrasive wax.

CAUTION : Never clean apparent fiberglass

and plastic parts with strong detergent,

degreasing agent, paint thinner, acetone, etc.

If the watercraft is to be stored outside, cover it

with an opaque tarpaulin to prevent sun rays and

grime from affecting the plastic components, wa-

tercraft finish as well as preventing dust accumu-

lation.

CAUTION : The watercraft must never be

Ieft in water for storage. Never leave the

watercraft stored in direct sunlight.

Anticorrosion Treatment

Wipe off any residual water in the engine com-

partment.

Spray BOMBARDIER LUBE lubricant over all me-

tallic components in engine compartment.

Lubricate the throttle cable with BOMBARDIER

LUBE lubricant.

The seat should be partially left opened during

storage (the hood for the HX). This will avoid en-

gine compartment condensation and possible cor-

rosion.

NOTE : If the watercraft is stored outside

with seat (or the hood for the HX) partially

opened and without a tarpaulin, unscrew the rear

drain plug in order to avoid water build up in the

bilge during rainfall. Tilt the watercraft to the rear

so that water can flow out.

Additional Recommended Protection

In cool regions (where freezing point temperature

may be encountered), cooling system should be

filled with water and antifreeze solution.

CAUTION : Always use ethylene-glycol

anti-freeze containing corrosion inhibitors

specifically recommended for aluminum en-

gines.

NOTE : The engine will not have to run dur-

ing this operation.

F01I0BA

F05I09A