Technical data

Section 04 ENGINE
Sous-section 01 (REMOVAL AND INSTALLATION)
04-01-2
Disconnect magneto wiring harness.
ALL MODELS EXCEPT XP
1. Unplug connector
XP MODEL
1. Unplug connector
Tuned Pipe
To remove tuned pipe, refer to ENGINE 04-05.
Air Intake Silencer
To remove air intake silencer, refer to FUEL SYS-
TEM 06-02.
Carburetor(s)
All Models Except the HX
To remove carburetor(s), refer to FUEL SYSTEM
06-03.
HX Model Only
Disconnect choke and throttle cables from carbu-
retors.
Disconnect fuel supply and fuel return hoses.
Engine Support Mounts
All Models Except the HX
Remove engine support mount screws.
NOTE : Be careful when removing engine
support mount screws, shims could have
been installed between engine support and rub-
ber mounts. To ease engine / jet pump alignment,
indicate shim location for reinstallation.
TYPICAL - ALL MODELS EXCEPT XP
1. Shim
XP MODEL
1. Rear support
2. Front support
3. Shim
F01H09A
1
F01D7NA
1
F01D32A
1
F01D8PA
1
3
3
2
www.SeaDooManuals.net