Technical data

Section 04 ENGINE

Sous-section 01 (REMOVAL AND INSTALLATION)

04-01-3

HX Model

Loosen screws of engine rubber mount adapters.

NOTE : Rubber mount adapters sit on

shims which control engine / jet pump align-

ment. Always note position of shims for reinstal-

lation, to avoid altering engine alignment.

1. Adapter screw

Lifting Engine

All Models Except the XP

Engine can be easily lifted using the following

suggested tools.

– Cut porcelain from 2 old spark plugs.

– Weld a lock washer approximately 20 mm dia-

meter on each spark plug as shown.

1. Weld a lock washer

2. Old spark plug

Remove spark plugs and replace by special tools.

Hook a sling into holes of special tools.

Using a chain block, a hoist or other suitable equi-

pment, slightly lift engine to ease the remaining

component removal.

CAUTION : Take care not to damage cable

or oil injection hoses.

XP Model

Engine can be easily lifted by inserting a hook into

exhaust manifold eyelet.

Using a chain block, a hoist or other suitable equi-

pment, slightly lift engine to ease the remaining

component removal.

CAUTION : Take care not to damage cable

or oil injection hoses.

Remove rear engine support.

1. Rear support

F05D09A

F01D0AA

F01D7OA

F01D7PA