Technical data

Section 04 ENGINE
Sous-section 01 (REMOVAL AND INSTALLATION)
04-01-6
TYPICAL - ALL MODELS EXCEPT THE XP
1. Shim
XP MODEL
1. Rear support
2. Front support
3. Shim
CAUTION : Whenever shims are used to
correct alignment, never install more than
6 mm (0.240 in) shim thickness. If alignment
cannot be obtained verify for engine support
bending.
Engine Support Screws
Apply Loctite 242 (blue) on screw threads.
Retorque engine support screws to 25 N•m (18
lbf•ft) when procedure is completed.
NOTE : Whenever alignment tool is not uti-
lized, apply BOMBARDIER LUBE lubricant
on its shaft and inside the housing to eliminate
possible corrosion.
Final Inspection
Check throttle cable condition and lubricate cable
with BOMBARDIER LUBE lubricant. After its ins-
tallation, properly adjust and bleed oil injection
pump as specified in LUBRICATION SYSTEM 07-
02.
Pressure test fuel system, refer to FUEL SYSTEM
06-01.
Verify all connections and hoses condition.
Run engine and ensure there is no leakage.
CAUTION : Water must be supplied to
cool the engine.
F01D32A
1
F01D8PA
1
3
3
2
-
-
www.SeaDooManuals.net