Technical data

Section 04 ENGINE

Sub-Section 05 (EXHAUST SYSTEM)

04-05-8

16, Sealing Ring

HX and XP Model Only

Make sure to install the sealing ring on tuned pipe

cone if it was removed.

TYPICAL

1. Sealing ring

Apply a thin layer of heat resistant sealant (P/N

413 709 200) all around sealing ring.

All Models

18,19, Sleeve and Rubber Bushing

Ensure rubber bushings and sleeve are not dam-

aged and are properly installed into tune pipe sup-

port(s).

CAUTION : Damage to bushings and/or

sleeve will eventually cause stress to tune

pipe and may cause cracking.

20, Gasket

Make sure that gasket is properly located on ex-

haust manifold prior to finalizing pipe installation.

4,6,7,8,23, Clamp, Screw and Nut

Apply Loctite 242 (blue) on stud and retaining

screw threads. Hand-tighten nut and screws and

assure that tuned pipe bushing(s) rests against

manifold.

Refer to the following illustration for the torquing

sequence.

TYPICAL

Step : Torque screw(s) of tuned pipe cone to 12 N•m (9 lbf•ft)

Step : Torque nut and screws of tuned pipe flange in a criss-cross

sequence to 12 N•m (9 lbf•ft)

Step : Repeat the torquing sequence by retightening all fasteners

to 25 N•m (18 lbf•ft)

Step : Torque clamp to 10 N•m (88 lbf•in) (if applicable)

XP Model Only

7,9, Screw and Nut

Torque nut and screws of tuned pipe head flange

to 40 N•m (30 lbf•ft).

F01D82A

7 6

F01D69A

F01D0IA

1 3

2 3