Caution :You must read this before you proceed Accent Chair Label Picture Description QTY A Chair Base 1 B Chair Back 1 C Front Leg 2 D Back Leg 2 1 of 5
Label Picture Description QTY ① Plastic Washer 4 ② Rubber Washer 4 ③ Bolt 1 Before Beginning Assembly: Chair Back(B) Chair Base(A) Front Leg(C) FRONT FACING Back Leg(D) Front Leg(C) 2 of 5
This Accent Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Accent Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Chair Base(A) Position the chair on its back,as shown. Unzip to open pouch and remove the 4 wooden legs and hardwares,close the pouch.
Put the chair onto a flat table as shown in pix. Attach the Back Leg(D) into the mounting position of Chair Base(A) by placing one Plastic Washer( ①) and one Rubber Washer( ②) on the threaded stem. Repeat the same process to install the remaining three Legs. Tighten by turning the Leg clockwis. Note: The use of Plastic Washer( ①) are OPTIONAL and are especially useful to help alleviate slight wobbles. Some Legs may need more than one Plastic Washer whilst some Legs may not need any.
Step 4 Chair Base(A) Put the chair onto a flat table as shown in pix. Screw the Chair Base(A) and the Chair Back(B) with the Bolt(③). Step 5 Stand the Accent Chair right side up. Your Accent Chair is ready for use. Your Accent Chair can only be used on a flat, level surface.