User`s manual

ARS-3020 User’s Manual

(3). The HDD’s power LED blinks red for 1 second and green for 9 seconds

The system has detected a bad track. Please get a good hard drive.

(4). The System doesn’t show all HDDs in normal mode

Inspect the BIOS screen while booting up the system. See if it displays LUN=3.

If not, follow the BIOS setup procedure stated in 2.3.

(5). The HDD’s capacity isn’t found in the system

Here let’s take Windows XP as an example.

1. Right-click “My Computer” and enter “Manage”.

2. Choose “Disk Management” under “Storage”, and a given hard drive ID will

appear on the right lower corner of the window.

3. If the newly installed hard drive has no ID, “Partition” and then “Format” it.

4. If the newly installed hard drive doesn’t appear on the screen, it might be

improperly installed or damaged. Try again.

PRIMARY_MASTER_HDD_GOOD_LED

PRIMARY_SLAVE_HDD_GOOD_LED

SECONDARY_MASTER_HDD_GOOD_LED

SECONDARY_SLAVE_HDD_GOOD_LED

PRIMARY_MASTER_POWER_LED

PRIMARY_SLAVE_POWER_LED

SECONDARY_MASTER_POWER_LED

SECONDARY_SLAVE_POWER_LED

SYSTEM_POWER_LED

CN5

CN21

CN6

red

green

Figure 3-2