User`s manual

9
ARS-3020 User’s Manual
Table 2-1
2.2 Set the SCSI ID
On the rear panel of ARS-3020 there is a SCSI ID switch as figure 2-3 shows. Set the
SCSI ID by adjusting the switch up or down. [Don’t set ID 7. It is for SCSI card.]
Setting SCSI ID & configuration mode: Be sure that each device has a unique ID num-
ber (see 1.7). No matter how many ARS-3020s (up to 15) are installed and connected,
the SCSI ID set on every switch cannot be the same. The selectable number for ARS-
3020 is from 0 to 15.
.oN DELehT sutatSyalpsiDehT
1DELrewoP
enilnO:thgilneerG
enilffO:thgiloN
2
s'DDHretsaMyramirP
DELlangiSrewoP
enilnO:thgilneerG
enilffO:thgildeR
rotcesdaB:thgildergniknilB
3
s'DDHretsaMyramirP
DELlangiSsseccA
sseccA:thgilwolleY
sseccaoN:thgiloN
4
s'DDHevalSyramirP
DELlangiSrewoP
enilnO:thgilneerG
enilffO:thgildeR
rotcesdaB:thgildergniknilB
5
s'DDHevalSyramirP
DELlangiSsseccA
sseccA:thgilwolleY
sseccaoN:thgiloN
6
s'DDHretsaMyradnoceS
DELlangiSrewoP
enilnO:thgilneerG
enilffO:thgildeR
rotcesdaB:thgildergniknilB
7
s'DDHretsaMyradnoceS
DELlangiSsseccA
sseccA:thgilwolleY
sseccaoN:thgiloN
8
s'DDHevalSyradnoceS
DELlangiSrewoP
enilnO:thgilneerG
enilffO:thgildeR
rotcesdaB:thgildergniknilB
9
s'DDHevalSyradnoceS
DELlangiSsseccA
sseccA:thgilwolleY
sseccaoN:thgiloN