User`s guide

SS-1200-FCAL User Guide

• The 'Manual start' option jumper has been fitted to the ESI/Ops panel module during installation, thus

disabling the drive auto start function. If manual start has been selected, then Drive Start commands must be

issued to each drive in order to start their motors

• There is a power problem (an alarm and power fault indication would normally be active).

3.4.1 Disk Drives LEDs

Each drive carrier incorporates two indicators, an upper (GREEN) and lower (AMBER). In normal operation the

Green LED will be ON and will flicker as the drive operates.

3.5 Power Down

to power the enclosure down,

either

• Place the Enclosure in STANDBY Mode (See Service Mode operation above).

• Remove AC Mains at the power source