Operating instructions

59
S.F. In UncompHD only. Select between segmented and non-segmented frame on the
input. S.F. ON or S.F. OFF.
Comb Filter
Select ON or OFF. Enables or disables the 3 line comb filter on the composite
video input.
7.10 Vid OUT
The Video Output settings below affect the video on the output (during playback from the drive)
Out
Select the video format on the output (YUV, RGB, S Video)
See section 4.1 for information on what formats are available simultaneously.
CH PH
Increase or decrease the chroma phase from 0 to 360.
HTRIG
Horizontal Trigger adjustment. Set the HTRIG adjustment ON or OFF.
HTRIG +
Enter the Horizontal Trigger value.
VTRIG +
Vertical Trigger adjustment. A positive number will move the picture
upwards, and a negative number downwards.
Black 7.5 IRE Used in NTSC only. Sets the black level to 0.0IRE for the Japanese
standards and 7.5IRE for the American standards.
PAL Switch
Select 0 or 1. Set the value according to the PAL standard used in your area
(A or B)
BIW Pos
Time Code Burn-in window. Position on the screen at Top-Left, Top-Center,
Top-Right, Bottom-Right, Bottom-Center, Bottom-Left
(Analog Video Outputs Only)
(For HD always present on the standard definition composite output.
Available on HD-SDI and YpbPr only when enabled)
BIW mode
Select between off, black on white, or white on black numerals.
VITC Out
Vertical Interval Time Code. Select off or the line number to output VITC on
(10 to 18 for NTSC and 6 to 20 for PAL)
(Recommended Values: NTSC:14 - PAL:19)
CC Out
Close Caption. Set to on or off to allow close caption to pass through the V1.
(Analog and SDI Video)
Blank
Select all or none. Will either blank or show the extra lines for 512 line
(NTSC) or 608 line (PAL) recordings.
Pattern
Video Pattern. Select on or off.
S.F. Out UncompHD Only. Select between segmented and non-segmented frame on
the output. S.F. On or S.F. off.
7.11 Aud IN LVL
Sets the audio input level for each analog audio channel separately.
7.12 Aud OUT LV
Sets the audio output level for each analog audio channel separately.
This feature is not yet enabled.
7.13 Edit Prst
The settings in Edit Presets allow for the insert/overdub of audio, time code or video individually, while
the non-selected track(s) are monitored at the same time. The settings are used for manual insertion.
This is not a recommended practice. Doremi Labs strongly recommends using an edit controller.