User guide

Introduction
5
1.3.2.1 Ops Panel Indicators and Switches
The Operator Panel includes Light Emitting diodes (LEDs) which show the status for all modules and an Audible
Alarm which indicates when a fault state is present. The indicators and switches listed in the following table are
located from left to right on the panel, as shown in Figure 1–7.
Figure 1–7 Ops Panel Indicators and Switches
1.3.2.2 Drive Auto/Manual Start
A DIL switch is fitted to the rear panel of the ESI/Ops module.
• Switch 1 is used to disable the auto spin start function and allows spin up under Host command. (Please refer
to Sections 2.5.2).
• Switch 3 allows switching between alternate SES device slot address reporting schemes (Please refer to
Section 2.5.3).
Figure 1–6 ESI/Ops Panel Installation
LED Indicator Symbol
System Status
Drive Status
Power & Cooling
Status
UPS Status
Power Standby Status
Switches
Push-button Audible Alarm Mute
Push-button Standby/Operational switch
Rotary Keylock - Run/Service activate