User guide

Galaxy 55 User Guide
32
2.12 Engaging the Anti-tamper Locks
The Anti-tamper locks are fitted in the drive carrier handles and are operated through the small round cutout in the
lower part of the handle trim piece. In the locked position a red indicator is visible in the centre rectangular aperture
in the handle. (see Figure 2–23)
Drives are supplied with the locks set in the unlocked position.
2.12.1 Activating the Locks
1 Carefully insert the lock key provided into the cutout in the handle trim.
2 Locate the key into its socket.
3 Rotate the key through 90 degrees in an anti-clockwise direction until the indicator visible in the centre aperture of
the handle shows green.
4 Remove the key.
De-activation is the reverse of this procedure, that is:
• Rotate the key through 90 degrees in a clockwise direction until the indicator visible in the centre aperture of
the handle shows black.
Note A drive carrier cannot be installed if its anti-tamper lock is activated outside the Enclosure.
2.13 Blank Plates
2.13.1 Parts Check List
where applicable:
• Single bay Rear Blank plates
• 1x2 bay Rear Blank plates
• 1x3 bay Rear Blank plates
Figure 2–23 Activating the Anti-tamper Lock