User manual

any time.

 Yield – Temporary pause while a read/write operation takes

place.

 Paused– Temporary pause while another background runs.

Or a pause initiated by the user.

 Redundancy Check:

 Redundancy Check is a routine maintenance Procedure for

fault-tolerant disk arrays (those with redundancy) that

ensures all the data matches exactly. Redundancy Check

can also correct inconsistencies.

 Rebuild:

 When you rebuild a disk array, you are actually rebuilding

the data on one physical drive.

 When a physical drive in a disk array fails and a spare drive

of adequate capacity is available, the disk array begins to

rebuild automatically using the spare drive.

 If there is no spare drive of adequate capacity, but the Auto

Rebuild function is ENABLED, the disk array begins to

rebuild automatically as soon as you remove the failed

physical drive and install an un-configured physical drive in

the same slot.

 If there is no spare drive of adequate capacity and the Auto

Rebuild function is DISABLED, you must replace the failed

drive with an un-configured physical drive, then perform a

Manual Rebuild. See below.

IMPORTANT: IF YOUR REPLACEMENT DISK DRIVE WAS FORMERLY

PART OF A DIFFERENT DISK ARRAY OR LOGICAL DRIVE, YOU MUST

CLEAR THE CONFIGURATION DATA ON THE

REPLACEMENT DRIVE

BEFORE YOU USE IT.