Installation guide

Hawk 2LP family (Wide) information
Characteristics of the various drives covered by this
manual are listed in the following table.
Legend for table column meanings:
A = capacity, unformatted megabytes
B = capacity, formatted megabytes [1]
C = number of cylinders, user accessible
D = number of heads
E = + 5 V typical current [2], Amps
F = +12 V typical current [2], Amps
Model A B C D E F
ST32430W 2.59 GB 2.14 GB 3992 9 .70 .38
ST32430WD 2.59 GB 2.14 GB 3992 9 .90 .40
ST32430WC 2.59 GB 2.14 GB 3992 9 .70 .38
ST32430DC 2.59 GB 2.14 GB 3992 9 .90 .40
ST31230W 1.28 GB 1.06 GB 3992 5 .70 .38
ST31230WD 1.28 GB 1.06 GB 3992 5 .90 .40
ST31230WC 1.28 GB 1.06 GB 3992 5 .70 .38
ST31230DC 1.28 GB 1.06 GB 3992 5 .90 .40
"Wide" family products have a 16 bit SCSI data bus rather
than the normal 8 bit data bus. However, they can operate on
an 8 bit data bus.
Notes.
[1] Standard units are factory formatted with 512 data bytes
per sector with eight spare sectors per cylinder and 2
cylinders at inner tracks reserved for spares in addition
to capacity listed.
[2] Measured with an average reading DC ammeter. In-
stantaneous +12 V current peaks will exceed these
values.
Hawk 2LP (Wide) Installation Guide, Rev. A 15