Installation guide

Initial setup information
For the initial setup connect the cables or plug into a
mounted connector (if applicable), set the drive ID on
the bus and enable or disable the I/O line terminator
resistor packs (Hawk 2LP family "W" models only).
These procedures are described in paragraphs follow-
ing. Note whether drive model number ends in W, WD,
WC or DC.
SCSI interface cable connection
The Hawk 2LP family wide drives are SCSI interface
drives. System connection on "W" and "WD" models is
via a 68 pin SCSI connector. System connection for
"WC" and "DC" models is via an 80 pin SCSI and DC
power connector. The "WC" and "DC" models plug
directly into a PCB or bulkhead mounted mating 80 pin
connector. "WC" and "DC" drives should not be con-
nected to the host via a cable/connector. Pin 1 is noted
in Figure 2. Some cables have a contrasting color stripe
on one edge to indicate pin 1. On the Hawk 2LP wide
drives the I/O connector is keyed by virtue of its shape.
There is only one way it can mate with the mating input
connector. Strain relief is recommended at the cable in
drives using cables. Do not block system cooling air
flow in routing of cables.
16 Hawk 2LP (Wide) Installation Guide, Rev. A