Installation guide

Hawk 2LP (Wide) Installation Guide, Rev. A 17
DC Power connection
Hawk 2LP family "W/WD" model drives receive DC
power through a 4 pin connector mounted on the PCB
in line with the SCSI I/O connector. See figure below.
Figure 1. DC power connection, 68 pin SCSI I/O
connector
Hawk 2LP "WC" and "DC" model drives receive power
from the host computer through the 80 pin combined
SCSI I/O and power connector. No separate DC power
connector is provided on the "WC" and "DC" drives
(See Figure 2b).
J1-DC Power
Connector
Pin
1P
2P
3P
4P
Power
+12V
+12V ret
+ 5V ret
+ 5V
J1
1P2P3P4P
68 Pin SCSI I/O
Connector
J1-Auxiliary