Installation guide
Hawk 2LP (Wide) Installation Guide, Rev. A 25
J1-DC Power
J1
68 Pin
SCSI I/O
Connector
Drive
HDA
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
A
3
A
2
A
1
SCSI ID = 0
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
A
0
[3]
J1-Auxiliary
Pin 1A
[3]
4P 3P 2P 1P
PCB
Pin 1
+5V
Ground
11 9 7 5 3 1
[4]
Host Alternate
Usage Plug:
Ground
8 6 4 2
Optional connections to switching circuits in host
equipment to establish drive ID. Pins 2, 4, 6, and
8 are driven low for 250 ms after PWR ON and
reset to allow jumper selectable SCSI ID. [4]
Dashed area is optional host circuitry (external to the drive)
connected to host supplied optional usage plug. Drive PCB
circuitry for Pin 8 includes a 150 Ω series resistor.
[4]
Remote LED
+5V
Figure 3b. Drive configurator Hawk 2LP family
W/WD models