Installation guide

J2
Drive Front
Pin 1
End
J6
Pin 1
J2
J1
Delay
Motor Start
Enable
Motor Start
Write Protect
Parity Option
Jumper
Positions
T
E
D
S
M
E
W
P
P
E
S
S
T
P
T
P
[8][8]
Pin 1
HDA
Drive with HDA up, 
PCB down, viewed from front
J6
[1]
+5V
Ground
SCSI ID = 0
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
Reserved
A
2
A
1
A
0
[7]
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
Shipped with cover installed.
Do not install jumpers; retain cover
unless 20 pin plug is installed.
11 9 7 5 3 1
Remote LED
[4]
Optional connections to switching circuits in host 
equipment to establish drive ID. Pins 2, 4, 6 and 
8 are driven low for 250 ms after PWR ON and 
reset to allow jumper selectable SCSI ID.
Dashed area is optional host circuitry (external to the drive) 
connected to host supplied optional usage plug. Drive PCB 
circuitry for Pin 8 includes a 150 Ω series resistor.
Do not connect anything to pins 13-20.
+5V
Host Alternate
Usage Plug:
Reserved
Pins
8 6 4 2
Ground
[4]
A
3
Figure 3c. Drive configurator for Hawk 2LP family
WC/DC models
26 Hawk 2LP (Wide) Installation Guide, Rev. A