Installation guide

32 Hawk 2LP (Wide) Installation Guide, Rev. A
continued from previous page
future time when the ID is changed the
user could fail to configure both the
same. Default is ID = 0.
For "WC" and "DC" models refer to Note
[7].
Models "W" and "WD" only
BUSY These pins used to connect a cable for a
LED remote BUSY LED indicator. J6 Pin 11
(top, nearest HDA), or J1-Aux Pin 11 the
anode connection, connects in the drive to
the +5V supply. J6 Pin 8 (bottom), or J1-
Aux Pin 8, the cathode connection, con-
nects in the drive to signal common through
the emitter-collector junction of a transis-
tor switch and 150 ohm series resistor that
controls the LED on/off condition.
Model "WC/DC" only
BUSY Time shared (see Note [4]) pins used to
LED connect a cable for a remote BUSY LED
indicator. Pin 4 (bottom), the cathode con-
nection connects in the drive to GRD
through the emitter-collector junction of a
transistor switch and 150 ohm series re-
sistor that controls the LED on/off condi-
tion. LED signal in J1 may be used in-
stead. See Note [2].