Specifications

Hawk 2XL Product Manual, Rev. B 15
5.0 Reliability specifications
The following reliability specifications assume correct host/drive operational interface, including all interface
timings, power supply voltages, environmental requirements and drive mounting constraints (see Section 8.4)
Note.
[1] Error rate specified with automatic retries and data correction with ECC enabled and all flaws reallocated.
5.1 Error rates
The error rates stated in this specification assume the following:
a. The drive is operated per this specification using DC Power as defined in this Manual (see Section 6.2).
b. The drive has been formatted with the SCSI FORMAT commands.
c. Errors caused by media defects or host system malfunctions are excluded from error rate computations.
Refer to Section 3.2, “Media Characteristics.”
5.1.1 Environmental interference
When evaluating systems operation under conditions of Electromagnetic Interference (EMI), the performance
of the drive within the system shall be considered acceptable if the drive does not generate an unrecoverable
condition.
An unrecoverable error, or unrecoverable condition, is defined as one that:
1. Is not detected and corrected by the drive itself;
2. Is not capable of being detected from the error or fault status provided through the drive or SCSI interface;
or
3. Is not capable of being recovered by normal drive or system recovery procedures without operator inter-
vention.
5.1.2 Read errors
Before determination or measurement of read error rates:
a. The data that is to be used for measurement of read error rates must be verified as being written correctly
on the media.
b. All media defect induced errors must be excluded from error rate calculations.
5.1.3 Write errors
Write errors can occur as a result of media defects, environmental interference, or equipment malfunction.
Therefore, write errors are not predictable as a function of the number of bits passed.
If an unrecoverable write error occurs because of an equipment malfunction in the drive, the error is classified
as a malfunction affecting MTBF. Unrecoverable write errors are those which cannot be corrected within two
attempts at writing the record with a read verify after each attempt (excluding media defects).
Seek Errors
Less than 1 in 10
7
seeks
Read Error Rates [1]
Unrecovered Data Less than 1 sector in 10
14
bits transferred
Miscorrected Data Less than 1 sector in 10
21
bits transferred
MTBF 800,000
Service Life 5 years
Preventive Maintenance None required
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com