Installation guide

3
3. When the installation is complete, you will be given the option to launch.
To launch, click FINISH. A MaxNeighborhood window will appear with a
“SEARCHING, Please Wait….” message. This message indicates that your
computer is searching for MaxAttach units. This process may take a few
minutes depending on your network configuration.
4. When the search is complete, the grid window will display the MaxAttach
unit(s) on your network. Under the Network tab, your screen will display the
status, the unit name, the IP address and workgroup name of each unit.
4 Launching the Configuration Wizard
1. To launch the Configuration Wizard, highlight and double-click on the name of your
MaxAttach unit in the MaxNeighborhood window. The name will be “MA” plus the last
six digits of the unit serial number.
2. The Configuration Wizard will appear in your web browser window. It will walk you
through setting the clock, assigning an administrator password and assigning a unit
and workgroup name.
3. Click Next to get started. If the Configuration Wizard doesn’t launch, please
check Troubleshooting Section 10.4.