Product manual

The post error (PER) bit is not supported.
The
disable transfer on error (DTE ) bit is not supported.
The
disable correction ( DCR ) bit is not supported.
Byte 3
The
read retry count field is the maximum number of times
the drive attempts its recovery algorithms. The read retry
count field has a range of 0 through 20
H
.
Byte 4
The
correction span is the size of the largest read data
error, in bits, on which ECC correction is attempted. The
drive can correct up to 64 bits. Longer errors are reported
as nonrecoverable.
Byte 5
The
head offset count is not implemented. Head offsets
are performed as part of the drive’s retry algorithms.
Byte 6
The
data strobe offset count is not implemented.
Byte 7
Reserved
Byte 8
The
write retry count field contains the maximum number
of times the drive attempts its recovery algorithms. The
write retry count field has a range of 0 through 20
H.
Byte 9
Reserved
Bytes 10–11
The
recovery time limit field always has a value of FFFF
H
,
which means that the recovery time is unlimited.
C.2 Disconnect/Reconnect page (02
H
)
The Disconnect/Reconnect page is shown below. This table summarizes
the function, the default value and the changeability of each bit.
Bytes
Bits
7 6543210
0 PS (1) Page code (02
H
)
1 Page length (0E
H
)
2 (default) Buffer full ratio (99
H
)
changeable FF
H
3 (default) Buffer empty ratio (99
H
)
changeable FF
H
4–5 (default) Bus inactivity limit (0000
H
)
changeable 0000
H
continued
100 Medalist Pro 2160N/2160WC Product Manual, Rev. A