User`s manual

6
z 1 host port (eSATA or USB) to 4 Serial ATA hard disk drives.
z Compatible with SATA Gen1 and Gen2 host controllers.
z Compatible SuperSpeed USB 3.0 specifications, backward compatible with USB 2.0.
z Embedded fast Storage Processor.
z Ultra-fast 3Gbps host and device port capability.
z Greater than 200MBps sustained reads in R0 mode (limited by drives and host controller).
1.3.2 SATA FEATURES
The EliteRAID ER104UT(-B) provides the following Serial Advanced Technology Attachment (SATA) features:
z 1 eSATA host port to 4 SATA devices (Port Multiplier Functionality).
z Auto-negotiation between SATA I (1.5Gpbs) and SATA II (3Gpbs).
z Supports SATA II Gen2i and Gen2m (External SATA Connection, eSATA).
z Supports Hot-Plug on CLEAN MODE.
z Supports Native Command Queue (NCQ).
z Supports PM aware and non-PM aware host on RAID mode.
z Supports asynchronous signal recovery.
z Supports spread spectrum clocking.
z Supports BIST and loopback mode.
z Supports 48-bit LBA addressing.
z Supports ATAPI drives.
z Supports host control of hard disk drive staggered spin-up.
z Supports Asynchronous Notification.
z Output swing control and automatic impedance calibration for SATA II PHY.
1.3.3 USB FEATURES
The EliteRAID ER104UT(-B) provides the following Universal Serial Bus (USB) features:
z 1 USB 3.0 host port to 4 SATA devices.
z Operates at USB Super, full and High-speed rates (5Gb/s to 12Mb/s).
z OS independent, Driverless, Auto Configuration.
z Support USB Super-Speed, High-Speed and Full-Speed Operation.
z Supports and compatible with OHCI/UHCI/EHCI hosts.
z Support Mass Storage Class.
z
Support on line USB firmware update.
z Compliance with US
B 3.0 electrical specification, backward compatible with USB 2.0.
z Compliance with USB Mass Storage Class, Bulk-Only Transport Specification.
1.4 SPECIFICATIONS
z Four 3.5-inch SATA HDDs to a standard USB 3.0 or eSATA interface
z Power, PC Link, and four HDD LEDs.
z Support Clean, Large, Clone, R0, R1, R3, R5, R10 modes.