user manual

Removal and replacement procedures 23
3. Set the processor into the ZIF socket, and hold it in place while closing and latching the socket lever. Verify that
the processor is fully seated in the socket.
CAUTION: Failure to fully seat and latch the processor in the ZIF socket can result in damage to the processor,
processor memory board, or both.
4. If reusing the processor and heatsink (spare part number 383420-001), clean the top of the processor and the
bottom of the heatsink using an alcohol pad (included with the thermal grease kit) or a clean dry wipe to
remove all traces of the old thermal grease. Allow the alcohol to evaporate before continuing.
CAUTION: The processor should be installed on the processor memory board before cleaning to prevent
damaging the pins.
5. Squeeze one-half of the contents if the syringe contains 1.0 gm (0.5 ml) or the entire contents if the syringe
contains 0.5 gm (0.25 ml) evenly onto the top of the processor.
6. Install the heatsink, ensuring that it is properly seated before latching it in place.
7. Install the processor memory board.
8. Replace the access panel.
9. Replace server in the rack.
10. Power up the server.