Installation guide

1. Preparing to Install the System
Safety Considerations●
Required Tools●
System Description●
Status Lights●
System Peripherals●
2. Installing the Core System Components
Installing the Cabinet ●
Installing the System Console●
Installing the C419/C619 Modem for RSN Use●
Installing the PCI Cards and Cables●
3. Installing the Tape Drives
Installing the Stand-Alone T800-Series Tape Drives●
Installing the Daisy-Chained T800-Series Tape Drives●
Completing the Installation of Tape Drives on a Running System●
4. Booting the System
5. Configuring the RSN and C416/C619 Modem
Preparing to Configure the RSN●
Configuring the RSN●
Configuring the C419/C619 Modem●
Completing and Verifying Configuration of the RSN●
6. Sending the Installation Report
Preparing an Installation Report●
Sending an Installation Report to CAC●
Sample Installation Report●
Appendix A. Fault Isolation
General LED Information●
System Component LEDs
Power Supply LEDs❍
Disk Shelf LEDs❍
Suitcase LEDs❍
PCI Card LEDs❍
●
System Log and Status Messages●
Component Status
Software State Information❍
Hardware Status Information❍
●
Fault Codes●
Troubleshooting Procedures●
toc
file:///H|/CSDoc/leoinstall/toc.htm [01/14/2000 3:50:30 PM]