Installation guide
Table Of Contents
- Preface
- Electromagnetic susceptibility
- Electromagnetic compliance
- Electromagnetic compliance for the European Union
- Australian C-Tick
- Seagate technical support services
- General description
- Initial setup information
- General information
- SCSI ID jumpers
- Drive termination
- Terminator power
- I/O circuits and data path widths
- Providing adequate cooling
- Mounting the drive and connecting cables
- Formatting the drive
- Quick reference desktop system notes
- Setting the SCSI ID jumpers
- Terminating the drive
- Terminator power
- Other applicable jumper options
- Setting the SCSI ID jumpers
- Terminating the drive
- Terminator power
- Other applicable jumper options
- Setting the SCSI ID jumpers
- Terminating the drive
- Applicable jumper options
Barracuda 4XL Installation Guide, Rev. B 19
Initial setup information
The general information beginning on this page applies to all of
the Barracuda 4XL drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.
Drive models Page
ST34572N ST32272N 38
ST34572W/WD ST32272W/WD 42
ST34572WC/DC ST32272WC/DC 47
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
1
• Formatting the drive
1
This mounting procedure does not apply to “WC” or “DC” model
drives. To mount a “WC” or “DC” drive, plug the drive into the
system’s single connector attachment (SCA) position on the
system’s back panel.