Specifications

Section 10—CD-ROM Drive – CD-ROM Physical Configuration and Cabling
126 Application ModuleX Service 12/01
Honeywell
10.2 CD-ROM Physical Configuration and Cabling
CD-ROM pinning
(without DAT
drive)
The SCSI interface must be terminated by placing termination resistor
assemblies at the drive located at the end of the cable (farthest from
HDDT I/O board). The following illustration shows the proper pinning
(device address 2) and terminators for the CD-ROM when the
configuration does not include a DAT drive.
SCSI Address 2 and Termination
Jumpers Installed
(Use 51190624-900
If Needed)
Termination Resistors
Installed (Use 51192039-122)
51894