Product manual

D.2.4 Date Code page (C1
H
)
The Date Code page is shown below. The table summarizes the function
and the default value of each bit.
Bit
Byte
7 6 5 4 3 2 1 0
0 Peripheral qualifier Peripheral device type
1 Page code (C1
H
)
2 Reserved (00
H
)
3 Page length (03
H
)
4 Year
5–6 Week
Bytes 4 The
year field contains the year, in ASCII, that the firmware
was released.
Bytes 5–6 The
week field contains the week, in ASCII, that the firm-
ware was released.
D.2.5 Jumper Settings page (C2
H
)
The Jumper Settings page is shown below. The table summarizes the
function and the default value of each bit.
Bit
Byte
7 6 5 4 3 2 1 0
0 Peripheral qualifier Peripheral device type
1 Page code (C2
H
)
2 Reserved (00
H
)
3 Page length (01
H
)
4 Reserved MS PE SCSI ID
Byte 4 If the Motor Start (MS) bit is 1, the remote start enable jumper is
installed on pins 3 and 4 of the options jumper block. If the MS
bit is 0, the remote start enable jumper is not installed.
If the Parity Enable (PE) bit is 1, the parity enable jumper is
installed on pins 1 and 2 of the options jumper block. If the PE
bit is 0, the parity enable jumper is not installed.
SCSI ID is the SCSI ID of the drive.
122 ST3655 Family SCSI Drives Product Manual, Rev. A