User manual

Using S.M.A.R.T. Disk Monitor 177
SANTOOLS® is registered in US Patent and Trademark Office No 3,107,854 All rights reserved.
# Seeks >= 2/3 of disk:
# Seeks >= 1/3 and < 2/3 of disk:
# Seeks >= 1/6 and < 1/3 of disk:
# Seeks >= 0 and < 1/6 of disk:
# Seeks > 0 and < 1/12 of disk:
Overrun counter - times data available but not retrieved on pass:
Underrun counter - times disk was ready to write but buffer empty:
Device cache full read hits:
Device cache partial read hits:
Device cache write hits:
Device cache fast writes:
Device cache read misses:
B 0004 %d Device cache read misses:
DG146BAAJB:
Invalid DWORD count:
Disparity error count:
Loss of DWORD sync count:
Phy reset problem count:
# of Zero-length seeks:
# Seeks >= 2/3 of disk:
# Seeks >= 1/3 and < 2/3 of disk:
# Seeks >= 1/6 and < 1/3 of disk:
# Seeks >= 0 and < 1/6 of disk:
# Seeks > 0 and < 1/12 of disk:
Overrun counter - times data available but not retrieved on pass:
Underrun counter - times disk was ready to write but buffer empty:
Device cache full read hits:
Device cache partial read hits:
Device cache write hits:
Device cache fast writes:
Device cache read misses:
Power on time (in hours):
Max drive temp (C):
GLIST size:
Number of PFA Occurrences:
Total read commands:
Total write commands:
(IBM*) 03570*
# of blocks corrected on writes for cartridge:
Servo transient condition count on writes for cartridge:
# of RDF/ECC transient conditions on writes for cartridge:
# of write velocity errors on cartridge:
# of servo data acquisition write errors on cartridge:
# of RDF data acquisition write errors on cartridge:
# of servo data write errors on cartridge:
# of ECC data write errors on cartridge:
# of total write retries on cartridge:
# of Belcord Actions on writes on cartridge:
# of servo demark blocks written on cartridge:
# of volume control region write errors on cartridge:
# of blocks lifted for writes on cartridge:
# of write gap misses on cartridge:
# of blocks corrected on reads for cartridge:
Servo transient condition count on reads for cartridge:
# of RDF/ECC transient conditions on reads for cartridge:
# of read velocity errors on cartridge:
# of servo data acquisition read errors on cartridge:
# of RDF data acquisition read errors on cartridge:
# of servo data read errors on cartridge:
# of ECC data read errors on cartridge:
# of total sequence read errors on cartridge:
# of total read opposite errors on cartridge:
# of times tension adjusted higher than normal for read on cartridge:
# of times tension adjusted higher than normal for read on cartridge:
# of servo (set too high) read errors on cartridge:
# of servo (set too low) read errors on cartridge:
# of recovered read errors (dead reckoning nominal) on cartridge:
# of recovered read errors (dead reckoning high) on cartridge:
# of recovered read errors (dead reckoning low) on cartridge:
# of recovered read errors (filter coefficients changed) on cartridge: