User manual

Using S.M.A.R.T. Disk Monitor 179
SANTOOLS® is registered in US Patent and Trademark Office No 3,107,854 All rights reserved.
# of library recalibrations:
# of library drive mounts:
# of library priority cell mounts:
# of library magazine cell mounts:
# of library cleaning mounts to device:
# of library volume lifetime mounts:
Volume lifetime megabytes written:
Volume lifetime megabytes read:
# of drive lifetime mounts:
# of drive lifetime megabytes written:
# of drive lifetime megabytes read:
(IBM*) ULT3580*
Thread count:
Total data sets written:
Total write retries:
Total unrecovered write errors:
Total suspended writes:
Total fatal suspended writes:
Total data sets read:
Total read retries:
Total unrecovered read errors:
Total suspended reads:
Total fatal suspended reads:
Main partition remaining capacity (megabytes):
Alternate partition remaining capacity (megabytes):
Main partition maximum capacity (megabytes):
Alternate partition maximum capacity (megabytes):
Read compression ratio x 100:
Write compression ratio x 100:
Megabytes transferred to server:
Bytes transferred to server:
Megabytes read from tape:
Bytes read from tape:
Megabytes transferred from server:
Bytes transferred from server:
Megabytes written to tape:
Bytes written to tape:
(IBM*) 03590*
# of blocks corrected on writes for cartridge:
Servo transient condition count on writes for cartridge:
# of RDF/ECC transient conditions on writes for cartridge:
# of write velocity errors on cartridge:
# of servo data acquisition write errors on cartridge:
# of RDF data acquisition write errors on cartridge:
# of servo data write errors on cartridge:
# of ECC data write errors on cartridge:
# of total write retries on cartridge:
# of Belcord Actions on writes on cartridge:
# of servo demark blocks written on cartridge:
# of volume control region write errors on cartridge:
# of blocks lifted for writes on cartridge:
# of write gap misses on cartridge:
# of blocks corrected on reads for cartridge:
Servo transient condition count on reads for cartridge:
# of RDF/ECC transient conditions on reads for cartridge:
# of read velocity errors on cartridge:
# of servo data acquisition read errors on cartridge:
# of RDF data acquisition read errors on cartridge:
# of servo data read errors on cartridge:
# of ECC data read errors on cartridge:
# of total sequence read errors on cartridge:
# of total read opposite errors on cartridge:
# of times tension adjusted higher than normal for read on cartridge:
# of times tension adjusted higher than normal for read on cartridge:
# of servo (set too high) read errors on cartridge:
# of servo (set too low) read errors on cartridge:
# of recovered read errors (dead reckoning nominal) on cartridge:
# of recovered read errors (dead reckoning high) on cartridge:
# of recovered read errors (dead reckoning low) on cartridge: