User manual

SANtools® S.M.A.R.T. Disk Monitor (SMARTMon-UX)192
SANTOOLS® is registered in US Patent and Trademark Office No 3,107,854 All rights reserved.
Uncompressed entities:
(STK) 98*,T9*,T8*
Number of records with a recovered data check while reading:
Number of records with a recovered data check while writing:
Number of read temporary errors detected by software:
Number of write temporary errors detected by software:
Number of times a read record was retried before recovery passed or failed:
Number of servo position units (24 mm) used up by defects:
Number of times read blocks were recovered after one retry (read transients):
Number of times write blocks were recovered after one retry (write transients):
Adjusted read corrections:
Number of blocks read from tape hardware corrected:
Adjusted write corrections:
Number of blocks written on tape hardware corrected:
Number of errors detected by the controller when transferring data between the controller and interface
adapter:
Number of servo temporary off track errors:
(TANDBERG) SLR*
Total logical data blocks transferred:
Total physical blocks written to media:
Total physical blocks read from media (Read and Space operations only):
Approx remaining capacity of partition 0 (in KBytes):
Approx remaining capacity of current partition (in KBytes):
Approx maximum capacity of partition 0 (in KBytes):
Approx maximum capacity of current partition (in KBytes):
Number of file marks:
Number of set marks:
Number of minutes of motion since last head cleaning:
Number of head cleanings:
Total power-on minutes:
Total number of cartridge loads:
Number of servo lock retries:
Number of servo track seeks:
Number of lost servo locks on writes:
Number of write servo dropouts:
Number of lost servo locks on reads:
Number of read servo dropouts:
Current selected track number:
Cartridge serial number: (alphanumeric)
Number of times this cartridge loaded:
Number of beginning-of-tape markers passed for this tape:
Number of end-of-tape markers passed for this tape:
Number of cartridge write past counters:
Number of minutes cartridge has been in motion:
Write compression ratio (percentage - reset on cartridge change):
Read compression ratio (percentage - reset on cartridge change):
Percentage of data with compression between .89 and 1.2 - reset on cartridge change:
Percentage of data with compression between 1.2 and 1.6 - reset on cartridge change:
Percentage of data with compression between 1.6 and 2.2 - reset on cartridge change:
Percentage of data with compression between 2.2 and 3.6 - reset on cartridge change:
Percentage of data with compression greater than 3.6 - reset on cartridge change:
(TANDBERG) SDLT320*,SDLT330*
Read compression ratio (percentage - reset on cartridge change):
Write compression ratio (percentage - reset on cartridge change):
Number of MB transferred to host:
Number of bytes less than full MB transferred to host:
Number of MB read from tape:
Number of bytes less than full MB read from tape:
Number of MB transferred from host:
Number of bytes less than full MB transferred from host:
Number of MB written to tape:
Number of bytes less than full MB written to tape:
Number of loads over lifetime of the tape drive:
Number of cleaning sessions per cartridge:
Drive temperature in degrees C:
Vendor-specific (SCSI Inquiry) information: (All numeric unless otherwise marked)
(IBM) IC35*