User manual
SANtools® S.M.A.R.T. Disk Monitor (SMARTMon-UX)206
SANTOOLS® is registered in US Patent and Trademark Office No 3,107,854 All rights reserved.
security" implications that use the software to make sure that nobody has stolen a disk drive. Remember if you
have RAID5, then somebody could take a disk drive, and the host would run normally on the degraded LUN. Our
software detects disk drive removals.
· Since our software creates event log output and history files, then you can easily parse them with SNMP-based
management software to integrate Infortrend controllers (or for that matter, any controller or peripheral) into your
environment.
General Inquiry Usage
smartmon-ux -I+
Currently, the -I+ option is the only means by which our software reports vendor unique RAID information. If the
selected device is a LUN that is presented by a RAID subsystem with an Infortrend controller in it, you will get the
output that is highlighted in Blue. If it is not an Infortrend RAID, LSI RAID , or 3ware controller, the software
will report the EVPD data described in the Inquiry Page Viewer section.
Sample Output
# ./smartmon-ux -I+ /dev/rdsk/c1t0d0s0
SMARTMon-ux [Release 1.27, Build 5-JUN-2004] - Copyright 2001-2004 SANtools, Inc. http://www.SANtools.com
Discovered IFT 3102 S/N "3072051" on /dev/rdsk/c1t0d0s0 (SMART unsupported)(17501 MB)
Inquiry Text Page Data - ANSI defined fields
Device Type: disk
Peripheral Qualifier: Connected to this LUN
Removable Device: NO
ANSI Version: 2 (SCSI-2 ANSI X3.131:1994)
ISO/IEC Version: 0
ECMA Version: 0
Vendor Identification: IFT
Product Identification: 3102
Firmware Revision: 0223
Async event reporting: (AERC) NO
Supports 16-bit wide addresses: NO
Supports 32-bit wide addresses: NO
Supports ACKQ/REQQ handshaking: NO
Terminate task supported: NO
Response data format: 2
Relative addressing supported: NO
Supports request/ACK data transfer: NO
Normal ACA Supported: NO
32-bit parallel supported: NO
16-bit parallel supported: YES
Synchronous commands supported: YES
Linked commands supported: NO
Command queuing supported: YES
SAF-TE Enclosure services available: NO
VS bit (byte #6/bit #5 set): NO
VS bit (byte #7/bit #0 set): NO
RAID Controller Information:
Controller firmware revision: 2.23K
Controller boot firmware: 1.12H
Number of host channels: 2
Number of drive channels: 1
Processor memory: 2048 MB
Processor type: 5X86-133(WB)
Board serial number: 870329856
Mode flags bit map: 07030400
Write back: Disabled
Motor spin up: Disabled
Power up SCSI reset: Disabled
Battery backup support: No
Battery backup present: No
Error correction enabled: No
LUN assignment by SCSI ID support: Yes
SCSI LUNs > 0 supported: Yes
Spanning logical drives supported: No
Controller user-defined name: SFILE01
Controller make: IFT
201 210
53