User manual

SANtools® S.M.A.R.T. Disk Monitor (SMARTMon-UX)76
SANTOOLS® is registered in US Patent and Trademark Office No 3,107,854 All rights reserved.
SECTOR Register: 00
LBA LOW Register: 00
LBA MIDDLE Register: 00
LBA HIGH Register: 00
DEVICE Register: E0
Extended error bytes: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Listing of previous 5 commands executed before error (reverse-sequential):
Time(secs) Command Feature Sector LBA Low LBA Mid LBA High Device DevCtrl Command
Description
--------- ------- ------- ------ ------- ------- -------- ------ -------
------------------------
0.049 F8 00 00 00 00 00 E0 00 READ NATIVE MAX
ADDRESS
0.049 10 00 3F 00 00 00 A0 00 RECALIBRATE
0.049 91 00 3F 3F FF 3F AF 00 INITIALIZE DEVICE
PARAMETERS
0.023 EF 03 42 00 00 00 A0 00 SET FEATURES [Set
transfer mode]
0.018 EC 00 00 00 00 00 A0 00 IDENTIFY DEVICE
Note: All ATA registers represented by single HEX byte. The timestamp represents the elapsed
time in seconds since previous power=on. This wraps back to zero approximately every 50 days because
that
represents 2 ^ 32 milliseconds. Only the last 5 errors are retained by the disk drive per ANSI
specification.
Discovered Maxtor 5A250J0 S/N "A80F545E" on /dev/hdd (SMART Enabled)
Cumulative errors recorded by disk: 34 (Last 5 entries only)
Error #(34) Contents of registers when command register was written:
Device state field byte and description: 00 (Unknown)
Timestamp (lifetime powered-up hours): 1133
ERROR Register: 84 (Error: ICRC, ABORT)
STATUS Register: 51 (Error: DRDY, DSC, ERR)
SECTOR Register: 00
LBA LOW Register: 00
LBA MIDDLE Register: 00
LBA HIGH Register: 00
DEVICE Register: E0
Extended error bytes: 8E A0 4C 1B 00 00 03 00 9C 0B 06 00 00 00 00 00 00 00 0C
Listing of previous 5 commands executed before error (reverse-sequential):
Time(secs) Command Feature Sector LBA Low LBA Mid LBA High Device DevCtrl Command
Description
--------- ------- ------- ------ ------- ------- -------- ------ -------
------------------------
368.768 C8 00 01 00 00 00 E0 08 READ DMA
352.416 90 00 FF 3E C5 FA A0 08 EXECUTE DEVICE
DIAGNOSTIC
352.416 EC 00 00 3E C5 FA A0 08 IDENTIFY DEVICE
338.032 40 00 01 3E C5 FA E0 08 READ VERIFY
SECTOR(S)
337.904 E3 03 00 01 4F C2 A0 08 IDLE
Error #(33) Contents of registers when command register was written:
Device state field byte and description: 00 (Unknown)
Timestamp (lifetime powered-up hours): 1133
ERROR Register: 84 (Error: ICRC, ABORT)
STATUS Register: 51 (Error: DRDY, DSC, ERR)
SECTOR Register: 00
LBA LOW Register: 80
LBA MIDDLE Register: 61
LBA HIGH Register: 0F
DEVICE Register: E0
Extended error bytes: 18 C0 47 1B 00 00 03 00 6E 72 02 00 B0 03 00 0B 00 00 0C
Listing of previous 5 commands executed before error (reverse-sequential):
Time(secs) Command Feature Sector LBA Low LBA Mid LBA High Device DevCtrl Command
Description
--------- ------- ------- ------ ------- ------- -------- ------ -------
------------------------
1556.496 C8 00 08 80 61 0F E0 08 READ DMA
1556.480 C6 00 10 00 00 00 E0 08 SET MULTIPLE MODE
1556.480 10 00 3F 00 00 00 E0 08 RECALIBRATE
1467.984 E1 00 00 80 61 0F E0 0E IDLE IMMEDIATE