User manual

460
Use the Surveillance Station
Click the service link on “Administration” > “Applications” > “Surveillance Station” to connect to the
application. Enter the user name and password when you are prompted to.
No te : The Surveillance Station only supports 32-bit Internet Explorer version 7.0 or above.
To set up your network surveillance system by the NAS, follow the steps below:
1. Plan your home network topology
2. Set up the IP cameras
3. Configure the camera settings on the NAS
4. Configure your NAT router (for remote monitoring over the Internet)
Pla n y our hom e ne twork to polo g y
Write down your plan of the home network before setting up the surveillance system. Consider the
following when doing so:
i. The IP address of the NAS
ii. The IP address of the IP cameras
Your computer, the NAS, and the IP cameras should be connected to the same router on the LAN.
Assign fixed IP addresses to the NAS and the IP cameras. For example,
The LAN IP of the home router: 192.168.1.100
Camera 1 IP: 192.168.1.10 (fixed IP)
Camera 2 IP: 192.168.1.20 (fixed IP)
NAS IP: 192.168.1.60 (fixed IP)