User manual ZLIN Z50 (120) SEAGULL JP-5500070

ZLIN 50. Instruction Manual
10
Locker glue.
 4) Slide the collar to the axle and setscrew
the collars to secure the collar to the axle and
then slider the wheel on the axle with a drop of
oil on the axle so the wheel will spin freely when
installed. Prepare a second collar and tighten
the setscrew using hex wrench to secure the
collar to the axle.
 5) Place the wheel assembly in the wheel
pants. The threaded portion of the axle will fit
the notch of the wheel pant as shown.
 6) Slide the threaded end of the axle
through the hole in the bottom of the landing
gear leg. Use a washer and locknut to tighten
the axle to the landing gear. Make sure to use
threadlock on the nut so it won’t vibrate loose
in flight as shown.
 7) Tighten the setcrews using a hex
wrench to secure the collars on the axle over
the flat spot to retain the wheel as shown.
wheel Pant.
wheel.
M3.
wheel collar.
Lite-Plywood
block.
nut.
Axle.
Washer.
Landing Gear.
wheel Pant.
C/A glue.
wheel collar.
wheel.
Lite-Plywood
block.
Axle.
Washer.
M3.