User manual ZLIN Z50 (120) SEAGULL JP-5500070

www.seagullmodels.com
11
M4x20mm.
Locker glue.
INSTALLING THE MAIN LANDING GEAR
TO FUSELAGE.
 8) The blind nuts for securing the landing
gear are already mounted inside the fuselage.
 9) Using the hardware provided, mount
the main landing gear to the fuselage.
Repeat steps as above to attach remain-
ing wheel pants to the landing gear.
 10) Place the fuselage inverted on the
workbench in a suitable stand. Set the landing
gear in place and use a screwdrive to secure
the landing gear to the fuselage using bolts
M4x20mm and washers. Make sure to use the
threadlock on the bolts so they don’t vibrate
loose.
INSTALLING THE FUSELAGE SERVO.
Throttle servo .
Elevator servo .
Rudder servo .
 1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
 2) Secure the servos with the screws pro-
vided with your radio system.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
INSTALLING THE SWITCH.
Install the switch into the precut hole in the
side of fuselage.
Cut.
THROTTLE SERVO ARM INSTALLATION.
Adjustable Servo
connector.
Servo arm.
Loctite secure.
1 PCS.
Throttle servo arm.
Elevator servo .
Rudder servo .
Install adjustable servo connector in the servo
arm as same as picture below: