User manual ZLIN Z50 (120) SEAGULL JP-5500070

ZLIN 50. Instruction Manual
12
Machine Screw M4x30mm.
Pushrod wire.
140mm.
Switch.
MOUNTING THE ENGINE.
2) Use a pin drill and drill bit to drill a small
indentation in the mount for the engine mounting
screw.
 1) Position the engine with the drive washer
(140mm) forward of the firewall as shown.
3) Use a drill to drill the four holes in the engine
mount rails.
4.2 mm diameter.
4) On the fire wall has the location for the
throttle pusshrod tube (pre-drill).
7) Slide the throttle pushrod wire into the tube.
Position the engine between the mounts. Use
four M4x30mm machine screws to secure the
engine to the mount as shown.
5) Slide the pushrod tube in the firewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the firewall and
the fuel tank mount.
6) Connect the Z-bend in the 450mm throttle
pushrod to the outer hole of the carburetor arm.