User manual Isport 10-15cc Seagull

WWW.SEAGULLMODELS.COM
25
M2 clevis.
Fuel Tubing.
Hex Nut.
Hex Nut.
Fuel Tubing.
M2 clevis.
.
INSTALLATION PILOT .
1) Locate items necessary to install pilot,
cockpit panel, and canopy.
2) A scale pilot is included with this ARF.
e Seagull Pilot included tting well to
the cockpit. (or you can order others scale
pilot gures made by Seagull factory.
ey are available at Seagull distributors.)
If you are going to install a pilot gure,
please use a sanding bar to sand the base
of the gure so that it is at.
3) Position the pilot gure on the canopy
oor as show. Locate the oval shaped on
the canopy oor and remove the cover-
ing. Use epoxy to glue this into the base
of the pilot gure and glue the cockpit
panel in place with C/A glue, please see
pictures as shown.
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fu-
selage using a felt-tipped pen.
70mm
125mm
Epoxy.
- Apply a bead of canopy glue around the
inside edge of the canopy. Position the
canopy onto the hatch. Use tape to hold
the canopy secure until the glue fully
cures.