Instructions for use

SPACE WALKER II Instruction Manual.
12
INSTALLING THE MAIN LANDING GEAR.
1) The blind nuts are already mounted in-
side the fuselage.
4) A drop of C/A glue on the wheel collar
screws will help keep them from coming lose
during operation.
Repeat the process for the other wheel.
2) Using the hardware provided, mount the
main landing gear to the fuselage.
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
HORIZONTAL STABILIZER.
2) Slide the stabilizer into place in the pre-
cut slot in the rear of the fuselage. The stabi-
lizer should be pushed firmly against the front
of the slot.
3) With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
4mm X 20mm.
Draw center line.
Landing gear.