Instructions for use

SPACE WALKER II INSTRUCTION MANUAL.
15
PUSHROD INSTALLATION.
1) Align the tail wheel wire so that the wire
is parallel with the bottom of the rudder. The
control clasp has a predrilled hole through the
top of it. Slide this hole onto the tail wheel wire
while sliding the clasp over the bottom of the
rudder.
MOUNTING THE CONTROL CLASP.
2) Using a ruler and a pen place a mark onto
the bottom of the rudder. The back edge of
the clasp should line up with this mark.You may
find it necessary to bend the tail wheel wire
down slightly so it lines up with the clasp with-
out binding.
CONTROL HORN INSTALLTION.
1)Elevator and rudder control horn in place
using the same techinques to aleron control
horn.See picture below.
2) Position the elevator horns on the one
side of elevator. The clevis attach- ment holes
should be positioned over the hinge line.
Control Horn.
Mounting Screws.
Mounting Plate.
2mm X 20mm.
Rudder control horn.
Rudder pushrod.
Elevator pushrod.
3) Position the rudder control horn on the
left side of the airplane.Mount the control horn
parallel with the horizontal stabilizer.
Elevator control
horn.