Instructions for use

SPACE WALKER II Instruction Manual.
16
Throttle.
Rudder.
Switch.
Elevator.
INSTALLING THE FUSELAGE SERVOS.
3) While holding the clasp firmly in place,
use a pen and outline the clasp onto the rud-
der.
4) Remove the clasp, and using a model-
ing knife, remove the covering from inside the
lines you drew. Use 220 grit sandpaper and
carefully roughen the inside surface of the ny-
lon clasp.
5) Slide the clasp back into position and
carefully glue it into place using Kwik Bond Thin
C/A. Hold the clasp in place until the glue com-
pletely cures. Secure by 1 machine
screw.
INSTALLING THE SWITCH.
1) Install the switch into the precut hole
in the servo tray, in the fuselage, from the bot-
tom. Use the two screws provided with the
switch to secure it in place. Drill two 3/32”
holes through the tray for the screws to pass
through.
2) Make a push-pull lever out of scrap
wire. Attach the wire to the switch lever and
route the wire out the side of the fuselage,
through the hole you drilled.
3) Install the rubber grommets and brass
collets onto the elevator, rudder and throttle
servos. Test fit the servos into the preinstalled
servo tray. Because the size of servos dif-
fer, you may need to adjust the size of the
precut openings in the tray.
4) Position the servos into the servo tray
with the output shafts orientated as shown
below. Drill 1/16” pilot holes through the tray
for each of the mounting screws.
Secure the servos with the screws provided
from your radio system.
Some switches come with a hole drilled
through the switch tab for this very pur-
pose. If your switch does not, remove the
switch and drill a 3/32” hole through the middle
of the switch tab.
Control clasp.
2 MM x 12 MM.
Machine Screw
5) Install adjustable servo connector in
the servo arm.