Instructions for use

SPACE WALKER II INSTRUCTION MANUAL.
17
7) One at a time, hold the pushrods in po-
sition over the respective servos to check for
proper servo direction. If any servo turns in the
wrong direction, switch your radio’s reversing
switches as necessary to achieve the correct
direction.
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration
3) Position the battery pack in the fuel tank
compartment and the receiver just behind the
fuel tank . Use extra foam pieces to hold them
in position.
8) Install servos arm to servos. Notice the
position of the servo arms on the servos. See
picture as below.
INSTALLING THE RECEIVER AND BATTERY.
LANDING GEAR
6) Connect the elevator, rudder and throt-
tle servos to your radio’s receiver and turn on
the system. Set the trim tabs on the transmit-
ter to neutral and center the servo arms. The
elevator, rudder and throttle servo arms should
be perpendicular to the servos.
When balancing the airplane you may
need to move the battery or receiver for-
ward or after to achieve proper balance. In our
test airplane, using a .46 two stroke engine,
the battery and receiver were mounted as per
step # 4.
C/A glue.
Adjustable Servo
connector.
Servo arm.
( 3 PCS).
Thread locker glue.
INSTALLATION PILOT.
52mm.
52mm.
Silicon glue.