Instructions for use

SPACE WALKER II Instruction Manual.
2
INTRODUCTION.
Thank you for choosing the SPACE WALKER II ARTF by SEAGULL MODELS. The SPACE
WALKER II was designed with the intermediate/advanced sport flyer in mind. It is a semi scale
airplane which is easy to fly and quick to assemble. The airframe is conventionally built using balsa,
plywood and veneer to make it stronger than the average ARTF , yet the design allows the aeroplane
to be kept light. You will find that most of the work has been done for you already. The pushrods are
pre-made to the correct lengths, the motor mount has been fitted and the hinges are pre-installed
and pinned for security. Flying the SPACE WALKER II is simply a joy.
This instruction manual is designed to help you build a great flying aeroplane. Please read this
manual thoroughly before starting assembly of your SPACE WALKER II . Use the parts listing below
to identify all parts.
WARNING.
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is
capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU
ASSUME ALL RISK & RESPONSIBILITY.
If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C supplier
and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training
procedures designed to help the new pilot on his way to successful R/C flight. They will also be able
to advise on any insurance and safety regulations that may apply.
ADDITIONAL ITEMS REQUIRED.
 .40-.48 2-stroke engine.
.50-.72 4-stroke engine.
 4-channel radio with five servos.
 Glow plug to suit engine.
 Propeller to suit engine.
 Protective foam rubber for radio
system.
 Silicone fuel line.
 Stick-on weights for balance.
(If necessary)
TOOLS & SUPPLIES NEEDED.
 Thick cyanoacrylate glue.
 30 minute epoxy.
 5 minute epoxy.
 Hand or electric drill.
 Assorted drill bits.
 Modelling knife.
 Straight edge ruler.
 2mm ball driver.
 Phillips head screwdriver.
 220 grit sandpaper.
 90° square or builder’s triangle
Wire cutters.
 Masking tape & T-pins.
 Thread-lock.
 Paper towels.
PARTS LISTING.
FUSELAGE ASSEMBLY
 (1) Fuselage.
 (1) Pre-installed throttle pushrod &
tube.
 (1) Pre-installed servo tray.
 (1) Pre-installed motor mount.
 (1) Pre-installed rudder pushrod.
 (1) Pre-installed elevator pushrod.
WING ASSEMBLY
 (1) Right wing half with pre-installed
aileron.
 (1) Left wing half with pre-installed
aileron.
 (1) Plywood wing dihedral brace.
 (1) Covering strip for centre section
joint.
Tail section assembly
 (1) Vertical stabilizer with pre-
installed rudder.
 (1) Horizontal stabilizer with pre-
installed elevator halves.
Some more parts.