Instructions for use

SPACE WALKER II Instruction Manual.
6
2) Temporarilly install the aileron servo into
the servo mount, with the output shaft to-
wards the leading edge of the wing. Drill
1.5mm pilot holes through the mount. Re-
move the servo from the wing.
3) Tie a weight such as the fuel tank pickup
to a piece of string. Carefully feed the
thread through the wing and out of the servo
4) Attach servo lead to the aileron servo.
Attach the string to the servo lead and care-
fully thread it though the wing. Once you have
thread the lead throught the wing, remove the
thread so it can use for the other servo lead.
5) Tape the servo lead to the wing to pre-
vent it from falling back into the wing.
6) Reinstall the servo into the servo mount
and secure the servo inplace using the wood
screws provided with you radio system.
Electric wire.
String.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
Secure the servos with the screws provided
from your radio system.
1) Install the rubber grommets and brass
collets onto the aileron servo. Test fit the
servo into the aileron servo mount.
String.
Small weight.
Thread.
Small weight.
Thread.
Plastic tape.