Specifications

www.seagullmodels.com
11
 1) Install the pushrod housing through the
predrilled hole in the firewall and into the servo
compartment. The pushrod housing should
protrude 1/4" out past the front of the firewall.
Make a Z-Bend 1/4" from one end of the plain
wire pushrod.
MOUNTING THE ENGINE.
 6) Attach the Z-Bend in the pushrod wire to
the throttle arm on the carburetor.
 5) Bolt the engine to the engine mount using
the four machine screws. Double check that
all the screws are tight before proceeding.
 4) Remove the engine. Using an drill bit,
drill the mounting holes through the engine
mount at the four locations marked.
 2) Place your engine onto the engine
mount. Adjust the engine is centered of the
edges of the engine case.
 3) When you are satisfied with the align-
ment, mark the locations of the engine
mounting.
M3 x 10mm.
150mm.
4.2 mm diameter
Pushrod wire.
Machine Screw M4x30mm.